Answer Question
Double Line to Ground Fault Model Change
Hi
If you see in the below picture(attached file), double line to ground has been modeled in PSCAD such that there is a Rf between two phases. How to remove the Resistance between the two phases in double line to ground fault case and have only one Rf which is connected from (Phase-phase shorted) node to ground?
You may say that try to do fault analysis manually using switches without using blocks but i tried, it didn't work for me. I would like to know if there is any other solution.
Thanks
If you see in the below picture(attached file), double line to ground has been modeled in PSCAD such that there is a Rf between two phases. How to remove the Resistance between the two phases in double line to ground fault case and have only one Rf which is connected from (Phase-phase shorted) node to ground?
You may say that try to do fault analysis manually using switches without using blocks but i tried, it didn't work for me. I would like to know if there is any other solution.
Thanks