Staff Answer
Jun 27, 2014 - 08:07 AM
Hello Josef
I have attached a simple example of our Freq Scan component. It does a freq scan on the network at the point where it is connected and produces an output file. A file Reference Component was placed on the canvas so you can see the data that was produced.
Once you have run the simulation, you can load the data into Excel and plot it there.
I have attached a simple example of our Freq Scan component. It does a freq scan on the network at the point where it is connected and produces an output file. A file Reference Component was placed on the canvas so you can see the data that was produced.
Once you have run the simulation, you can load the data into Excel and plot it there.
--
George Wai,
Software Support & Development Specialist
Manitoba HVDC Research Centre
a division of Manitoba Hydro International Ltd.
211 Commerce Drive | Winnipeg, Manitoba, Canada R3P 1A3
T +1 204 989 1241 | F+ 1 204 989 1277
support@pscad.com | www.hvdc.ca | www.pscad.com
--
Add New Comment