Q&A Home
Help

PSCAD™ Q&A

Ask a Question

Ask your question here...

Home
Login

Search...

abraham

abraham

Robbust Chopper

I have problem in running these chopper circuits as attached. It was unable to run in slave, master configuration. Any help?

chopper.zip

Status: Open Jun 24, 2014 - 09:25 PM

Comments (0) | New Comment

Add New Comment

Do you have the same question? Follow this Question

Answer this question Report it

2answers

Staff Answer

GeorgeW

GeorgeW

Jun 25, 2014 - 12:42 PM

Hello

Make sure you are following the instructions found in the Chopper related video. You can find it by clicking the Video's tab on this website or by going to our Youtube channel

Root control dependent simulations with Master and slaves

http://www.youtube.com/watch?v=pOqhqO...

--

George Wai,

Software Support & Development Specialist

Manitoba HVDC Research Centre

a division of Manitoba Hydro International Ltd.

211 Commerce Drive | Winnipeg, Manitoba, Canada R3P 1A3

T +1 204 989 1241 | F+ 1 204 989 1277

support@pscad.com | www.hvdc.ca | www.pscad.com

--

0

0

Report it

Comments (1) | New Comment

By

abraham

on 6/26/2014 11:55:23 PM | Like (0) | Report

I can run it successfully...Thanks

Add New Comment

Answer

John Craig Muller, P. Eng.

John Craig Muller, P. Eng.

Jun 25, 2014 - 10:32 AM

What version of the software are you using?

I ran the Master/Slave simulation that you attached in PSCAD Free (v4.5) and they worked fine on my machine. Since I am not sure how you are running it, I am guessing maybe you did not run them as a set. All configurations like this must be run from a set and not from the selected project (Quick Run Standalone). Look at the pull down menu under the run button and start from a Simulation Set. In this example it is called 'simultaneous'.

Providing you have a compiler installed. It shoud work fine.

Craig Muller
Simulation Development Manager
PSCAD Development Group.

1

0

Report it

Comments (2) | New Comment

By

abraham

on 6/26/2014 10:46:24 PM | Like (0) | Report

I used PSCAD v4.5.3 SUL licensed. I have tried to run in Simulation set, but doesn't work. It mentioned "chopper1 is not configured as a standalone simulation, however it contains transmitter proxies"

By

abraham

on 6/26/2014 11:55:00 PM | Like (0) | Report

I can run it successfully. Thanks...

Add New Comment

Answer this question

Share Your Own Experience & Expertise

We look to ensure that every question is answered by the best people with relevant expertise and experience, the best answers include multiple perspectives. Do you have relevant expertise or experience to contribute your answer to any of these commonly asked questions?

Browse by Topic

Recently Active Members

Msoares

Msoares

585

dharmendranaidu

dharmendranaidu

545

minhquan.hcmut

minhquan.hcmut

775

jcgzipa

jcgzipa

670

Tools

Help

Search...

Q&A Home
Help

Knowledge Library
Legal

A Division of Manitoba Hydro International Ltd.

Please wait...