Staff Answer
May 01, 2014 - 01:10 PM
Hello All
Here is our Statistical Breaker example.
The component “statistical breaker close” was developed to simulate the normal distributed closing delays of a breakers main and pre-insertion contacts. It, together with components “multiple run” and “breaker”, can be used to study following aspects of breaker close:
1.The switching transients due to the different closing point on (voltage) wave (POW)
2.The impact of pre-insertion on the switching transients.
The example is ready to use with the GFortran compiler. If you are using the Intel Fortran compiler then you must change the link to the "Statistic_if.obj" file in the project settings.
--
George Wai,
Software Support & Development Specialist
Manitoba HVDC Research Centre
a division of Manitoba Hydro International Ltd.
211 Commerce Drive | Winnipeg, Manitoba, Canada R3P 1A3
T +1 204 989 1241 | F+ 1 204 989 1277
support@pscad.com | www.hvdc.ca | www.pscad.com
--
Source:
Add New Comment