Staff Answer
Apr 28, 2014 - 10:02 AM
Hello
You have an isolated signal with no source on the mail page. The signal is called "Src2" its essentially just a floating part of your netwok with no signal source. When the simulation tries to run, it doesn't know what to do with this. I am assuming you merely forgot to create a signal source in another part of your circuit.
You have an isolated signal with no source on the mail page. The signal is called "Src2" its essentially just a floating part of your netwok with no signal source. When the simulation tries to run, it doesn't know what to do with this. I am assuming you merely forgot to create a signal source in another part of your circuit.
Best regards,
George
--
George Wai,
Software Support & Development Specialist
Manitoba HVDC Research Centre
a division of Manitoba Hydro International Ltd.
211 Commerce Drive | Winnipeg, Manitoba, Canada R3P 1A3
T +1 204 989 1241 | F+ 1 204 989 1277
support@pscad.com | www.hvdc.ca | www.pscad.com
--
Add New Comment