Voted Best Answer
Jun 25, 2014 - 11:21 AM
From looking at your case it appears that you have a transmission line that is connected between BUS7 and BUS9 passing through BUS8. This is confusing the compiler thinking you need a connection, which then follows by an error. There must be two separate line between BUS7->BUS8->BUS9 for it to work properly.
I have included your case in an updated form that will work.
RMS Voltage display is a switch that you can turn on in the canvas settings.
Craig.
Craig Muller
Simulation Development Manager
PSCAD Development Group
I have included your case in an updated form that will work.
RMS Voltage display is a switch that you can turn on in the canvas settings.
Craig.
Craig Muller
Simulation Development Manager
PSCAD Development Group
By
Dear Sir could you please check this case.
Add New Comment