signal dimension mismatch pscad error
Greetings I keep getting an error, I am modeling a single phase inverter , but when i run it i get an error specifically "signal dimension mismatch pscad ", what could be the issue
Status:
Open Aug 16, 2022 - 04:29 AM
facts
1answer
Answer
Aug 24, 2022 - 10:20 PM
Hi
you should check every signal dimension on your project.
if you share the picture of your project I can tell you where the error is!
Source: www.simpowersystem.ir
Answer this question
Share Your Own Experience & Expertise
We look to ensure that every question is answered by the best people with relevant expertise and experience, the best answers include multiple perspectives. Do you have relevant expertise or experience to contribute your answer to any of these commonly asked questions?
Add New Comment