Voted Best Answer
Mar 14, 2019 - 03:23 AM
In PSCAD 4.6, BUS is reserved for only 3 phase systems. I have modified your case to replace buses with wires.
I keep getting the error Description Signal 'BUS2' dimension mismatch -> 3 != 1 and how to fix that?
I am trying to run a MMC based VSC hvdc system. However, I keep getting an error Description
Signal 'BUS2' dimension mismatch -> 3 != 1 and Description Meter 'multimeter' has mis-matched signal dimensions.
Signal 'BUS2' dimension mismatch -> 3 != 1 and Description Meter 'multimeter' has mis-matched signal dimensions.
Status:
Open Mar 12, 2019 - 11:26 PM
Do you have the same question? Follow this Question
1answer
Add New Comment