Voted Best Answer
Nov 08, 2018 - 04:31 PM
Hi,
Change the "Initial value for MPPT" inside the MPPT block
Change the "Initial value for MPPT" inside the MPPT block
Dou you know why MPPT voltage starts from under 0 ? I attached the solar array and Voc Isc values and output graph
I find the values of Voc and Isc values but the graph always starts from under 0 even if i chane the values of Voc and Isc. Also I found the pscad example very similar to this model, I tried to do simulation with examples' parameters but again its started from under 0. How can I fix this ??
Status:
Open Nov 06, 2018 - 04:20 AM
mppt, solar system, Isc, Voc, short circuit current, open circuit voltage
Do you have the same question? Follow this Question
1answer
Add New Comment