Add New Comment
Do you have the same question?
Follow this Question
Feb 13, 2017 - 11:55 PM
how to find the 3-phase current source in pscad,Sir?
There isn't any single block as "three phase current source" in the PSCAD,. but you can make it by using three single phase Current sources (CS). Go to the master lab, then sources. You can use three single phase CS. Go to the setting of the CS. You can set the initial phase of CS in "signal parameters" tab.
Alright, Sir Tahmasbi. I will try it later. Thanks.
Hi, Sir. I just tried changing the current source but still cannot running the simulation. Can you help me sir? I'm currently doing a study on lightning surge.
Sir Tahmasbi, what is the value for initial phase if we want to create the 3 phase source current?
The initial phases should be set to 0,120, 240 (degree) or 0,2pi/3, 4pi/3 (radian) to have a three phase current source inverter.
© 2013 Manitoba HVDC Research Centre · A Division of Manitoba Hydro International Ltd.