I build a very simple model of a source connected to an induction motor connected to a multimass
I configure the motor to use a multimass and configure the multimass to work with an induction motor
I connect the 3 terminals on the motor (W In , Te Out, and TL Out) to the corresponding terminals on the multimass
I connect the motor TL In to a real constant.
I get a compile error that says tmpu is floating.
For me this implies that there's no connection between TL In and TL out for the motor - although it's implied by a dotted line between these two terminals
If I connect TL In on the multimass to the real constant, the model compiles - but I don't thiink I should have to do this.
The connections and error message are shown below.
Add New Comment