Staff Answer
Jan 25, 2016 - 06:17 AM
Hello
The 2048 Output channel limit is put there as a realistic boundary for a simulation. When you have that many channels, the communication overhead between the simulation and PSCAD GUI becomes very high and will slow down your runs significantly.
Prom a practical standpoint, it is recommended to stay well below this limit.
The 2048 Output channel limit is put there as a realistic boundary for a simulation. When you have that many channels, the communication overhead between the simulation and PSCAD GUI becomes very high and will slow down your runs significantly.
Prom a practical standpoint, it is recommended to stay well below this limit.
Best regards,
George Wai
--
PSCAD Support
Manitoba HVDC Research Centre
a division of Manitoba Hydro International Ltd.
211 Commerce Drive | Winnipeg, Manitoba, Canada R3P 1A3
T +1 204 989 1241 | F +1 204 989 1277
support@pscad.com | hvdc.ca | pscad.com
PSCAD Q&A Forum: http://forum.hvdc.ca/
By
if you share the model,I will try to figure it out
By
Hello, thank you for the reply. I decreased the components in the project, and it is OK now.
By
Ok. Good luck
Add New Comment