Following the standard procedure, what I can make sure, I made a snapshot. When I wanted to restore it, PSCAD listed four Errors as below:
ERROR: Abnormal termination of EMTDC by READSTORS Non-standard Messages: Abnormal program termination. EMTDC Runtime Error: abnormally terminated. The simulation has errors and has terminated!
My soft environment is Win7 pro 64bit + PSCAD 32bit v4.5.0 My Laptop is I7-6700 + 16G ram
Thanks, but it is impossible.
Because the model is provided and encrypted by a third party.
I have the matched key file which can drive the model on my laptop only.
So, is there any solution?
By
Between store and restore, I did nothing at all.
By
It will be good if you share the model, then I will try to figure it out.
By
Thanks, but it is impossible.
Because the model is provided and encrypted by a third party.
I have the matched key file which can drive the model on my laptop only.
So, is there any solution?
By
I suggest you talk to the model provider
Add New Comment